Tuesday, 3 December 2013

.Chapter 1 - (Simple Stresses and Strains)

Lets start with a discussion on Simple Stresses and Strains --
        Defn of Stress :- The resistance to deformation per unit area is known as "Stress":-
       
                  Stress(σ) = P(Load) / A(Area).

               Where P = Load of force acting on the body, and
                     A = Cross-sectional area of the body.
        and the units of stress is Pascal(Pa) in S.I. system which is equal to 1 N/m2.
                        1 MPa = 1 X 106  = 1 N/mm2

                                                         1 GPa = 1 X 109 = 1 kN/mm2

Defn of Strain :- The deformation in length to a corresponding stress is known as "Strain":-

                  Strain (δ) = δl / l   =  δl = ε. l
                                   
               Where δl = change of length of the body, and
                      l = Original length of the body.

Note :- Strain does not have any unit.

Types of Stresses

Though there are many types of stresses, yet the following two types of stresses are important from the subject point of view :

1. Tensile stress.
2. Compressive stress.

Tensile Stress :- The stress due to which one may observe an increase in the length of the specimen subjected to stress is known as Tensile Stress.

Compressive Stress :- The stress due to which one may observe a decrease in the length of the specimen subjected to stress is known as Compressive Stress.

Note:- To every Stress there is a corresponding Strain.
            When a body is subjected to stress the body offers resistance constantly due to which the body tends to regain its original shape. But after certain amount of stress the deformation becomes   
a permanent deformation caused due to Stress applied. The resistance offered to a limit up until which the specimen may return to its original structure after the removal of Stress, such a  limit is known as elastic limit.

HOOKE's LAW

" When a material is loaded, within its elastic limit, the stress is proportional to the strain".

Mathematically ,
   
                         Stress       =  E = Constant.
                         Strain